logo logo

How To Properly Maintain Ball Screw

How To Properly Maintain Ball Screw

A ball screw is a popular screw used in so many industries and business machine and production because of the efficiency and accuracy. The high precision result could not be compared to other types of the screw and that is why many used this particular type of screw. However, this also means more maintenance and proper installation or it could be easily damaged. When damaged, you could use a recommended reading service to fix it in days that will cost you less than to replace it.

Close alignment of the ball screw journal mounting with the ball nut is needed for long life and positioning accuracy. Radial, bending or overturning loads can cut back the lifetime of the unit and its thrust bearings. Rough running and noise could be caused by overturning or bending. Radial, bending or over-turning hundreds can have a negative result on positioning accuracy. Improper adjustment of the subsequent can overload the ball screw and nut assembly, and contribute to ball screw failure and poor positioning accuracy. A ball screw should always be properly greased and clean. Otherwise, its lifespan is going to be reduced greatly. Once ball screws aren’t greased, the wear and tear life drops by the maximum amount as 85%. Lubrication reduces friction, prevents corrosion and permits the ball screw works in optimum capacity.

Use lubricants suggested by the machine manufacturer. As within the case of any high exactitude assembly, contamination by chips, dirt or different foreign matter can cause and ultimately induce ball screw failure. Bellows or telescopic covers square measure suggested if the surroundings include a high concentration of contaminants. Periodic examination for cleanliness and lubrication can extend the lifetime of the ball screw. Keep the unit hold on in plastic sleeves within the original shipping instrumentality. Leave the ball screw assembly within the protecting covering until the particular installation within the machine begins.

bottom

Comments are closed.

bottom
Share This